Compared to a Springfield Armory Combat Operator 9mm. Dan Wesson 6 inch barrel compared to the 5 inch 9mm barrel. Inside of the slide, note the lack of machining marks. Another shot of the businesses end. With its pin already half-way in the frame and through the barrel link, place the slide-stop as close to the plunger plunger is to its right as possible touching and firmly press inwards and upwards at the same time. Same shot with no flash. Note the barrel does have a slight crown to it.
The Return of the Dan Wesson Model 15 - Special Reports Article
Either way the Bruin is a absolute beast and should be able to take some of the hottest 10mm loads. The Dan Wesson revolver never really disappeared. Reassembly Question Hi Dave, Both of these have adjustable rear sights however, each have slightly different front sights: All contributions are greatly appreciated! Then just move slide forward.
Create a free website or blog at WordPress. Become a Redditor and subscribe to one of thousands of communities. Thanks for your reply. The slide-stop will push the plunger in and find its place. If you make a post, stick around and participate in your thread.
Good shot of how large this slide actually is, nice shot of the Duty Treat as well. Showing a government sized pistol for reference. DO NOT roll the slide stop upwards rubbing against the frame in the hope of snapping over the plunger. Dan Wesson 6 inch barrel compared to the 5 inch 9mm barrel. You can nitpick the fit of the extractor. Hide old embed code.